Motors - Crazypony D1103 10000Kv Brushless Motorsīattery - 350mAh 2s (I can't seem to find the brand)įPV Camera/VTX - Boldclash F-02 FPV AIO Camera RX - FrSky Ultralight XM Receiver (I also have a FrSky XSR receiver, though that might be a bit big for the build) Here is a list of parts for the build, if needed:įC and ESCs - USAQ Betaflight F3 Micro 6A 2S 4-In-1 Brushless ESC OSD Flight Controller Micro Cube Any advice would be very much appreciated! ![]() ![]() I am able to connect the FC to BetaFlight, however when I try to flash a newer version of OmniBus to the FC, the serial port consistently fails to open. The RX shows, with the little green light, that it is connected to the TX, so I don't believe that to be the issue, so I am lost! I am encountering a second issue, but I don't know if it related to the first. The issue I am facing is such: I have bound my RX (FrSky Ultralight XM Receiver) to my TX (Taranis Q X7) and soldered (correctly this time) it to my FC board (Super_S F3) but when I go into BetaFlight to check the receiver, nothing changes with inputs from the TX. I am attempting to build a 90mm 2s quad, however it is proving to be more difficult than anticipated! Anyway, I digress. ![]() I am fairly new to the building of multirotors, this build being my second, so maybe I am just missing some little piece that you experienced people can point out.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |